Shine Decor RGB Neon Rope Light Remote Pairing Instructions

When Shine Decor RGB led neon rope light's colors are out of control:

Step1. Plug off the neon rope light's power cord or switch off the power.

Step2. Then press on the 'brightness UP' button for 5 to 10 seconds without finger removal, and point the remote's blue signal light close to the receiver.

Step3. Keep pressing the 'brightness UP' button(don't remove your finger) and at the same time please plug the light's power cord in or switch on the power.

Step4. The neon rope light starts flashing means the pairing is done.


Shine Decor RGB Neon Light Remote Pairing Instructions

Back to blog

Leave a comment

Please note, comments need to be approved before they are published.